This is a work in progress - just getting the size dialed in.

This is a 4th Generation Apple TV remote control case - well really a half case. I don't want to get the beautiful back all scratched up and I didn't want to wait for the commercial cases to start arriving.

This is meant to be printed with Ninjaflex filament and with normal PLA or ABS, its likely going to be too small for the remote to fit it. The Ninjaflex version is meant to be tight to keep a good hold on the remote.

One thing of note, I did forget to make a hole in the back for the 2nd microphone (there are two on the remote, one on the top front and the other the bottom front). Easily fixed in the next version once I get the size and shape dialed in.

Doesn't Matter

No

0.2mm

100%

Ninjaflex filament was used on a Makerbot Replicator 2