I designed this for my Daughter's 10" Tablet and Smartphone. She has a loft bed, so instead of her electronics charging on top of her blankets (not a good idea) I made this wall mount. There are two files to print, one being the left side which also has the smart phone pocket and then the right side. Obviously because there are two pieces, the size of the width can be adjusted to the Tablet size.

Note that the cut out in the phone pocket is so you are able to charge your phone, tablet pocket also has a cut for charging but not every tablet may work with the charge cutout.

The Tablet & Phone wall mount can accommodate 10" Tablets +/- 2" with a thickness maximum of 20MM (+/- 1mm depending on your printer calibration) and the phone pocket will accommodate a maximum width of 83mm and a thickness of 16mm (again +/- 1mm).

No

No

.10-.20

50

Mount one side to your wall, place the tablet in it's pocket and holding in it's place, add the other side of the mount giving your self an extra 5-10mm of play. This extra room will make placing and removing of your tablet easier. Make sure you secure the mounts securely to the wall as the tablet and phone weight adds up.

Make you sure when you mount the second piece it is level with the first one.