This is a battery hold down for the Tattu 450 Mah battery. Front part has a clip for the VTX antenna to keep it out off the way. The rear part is just a clip, maybe print a couple just in case, wrecks and all or just use velcro for the rear but the front nose is handy. The inside of the nose is 16.5mm tall and 13mm wide. I printed the nose face down with supports for the wire clip. When put into my slicer need to scale up to 1000% so double check your scale before printing.
6-29 Added a longer front nose piece. Antenna holder is further back. And can possibly use without any other strap on the rear if you use one of my XT30 holders. Printed the same as other nose face down with supports.

Creality

CR-10 Mini

No

Yes

.16

100