Magnetic Helping Hands similar to a commercial design from Europe that seems to always be out of stock.

Additional parts required to make one "hand":

• 1 x 10mm x 5mm neodymium countersunk ring magnet
• 1 x 1.375" x 23/64" spring
• 1 x M4 x 30mm hex standoff
• 1 x M4 x 35mm hex standoff
• 2 x M4 x 10mm threaded steel ball ends
• 2 x M4 x 6mm screw
• 4 x M4 washers
• Heat shrink tubing for jaws
• Steel plate to use as work surface when complete

The magnet holder rings should be a tight press fit onto the magnets - a vise may help push them together. They do have a very slight ledge on the "top," so be sure to look for that and insert the magnet into the opposing side. If they are somewhat loose for any reason, a drop of CA glue will secure them.

Recommend making four of these to hold circuit boards, wires for soldering, small parts, etc.

Print Settings

Printer Brand:

Creality

Printer: 

CR-10S

Rafts:

No

Supports: 

No

Resolution:

0.2mm

Infill: 

38%

Filament: Hatchbox PETG

Notes:

Included G-code generated by Cura for a Creality CR-10S and takes 45-55 minutes to print.

Category: Hand Tools