GST-9 MOD1 Grip Handle (work in progress but 95% close on everything)

Please use this model for your own remixing. This is a VERY close design to the original but slightly different…

Those Looking to add a logo :

For those modifying for Logos or images ( Insert an Svg, or Image against Tangent planes and then input your commands. If you need help or something different I can assist, as I know not everyone has Fusion.

Remixes: 

Tried as hard as possible to add the important details early in the model so you can see what was built mostly in order of importance. The last 5 or so commands only control so much detailing. If you need help or something different I can assist.

Print Specs Highlights:

• Heavy bridging : is NEEDED towards the bottom of the plate around the upwards rear grip (tune your fans and settings for this area, I recommend 100% Fan) I will most likely be reverting this back to a flat plate 
• .15 Layer height: is recommended for those smaller detail logos you may be wanting to add, so tune as needed 
• Slow down your extrusion, There is not alot of support needed when you have the correct filament but please keep it slow as you may have a lot of detail in your remix / print
• -1.25 AND -1.50 Extruded Cuts for logos OR Keep the logo away from the grip Hole as it will create a small hole if too close

Design Specs Important Notes:

• Grip angle is roughly 15 Degrees
• 10mm - 12mm High is about the room you have to still hold a G19 magazine
•  Customizing my "flares" may or may not create a better print result 
• My “flare” areas have solid Infill for those who want to add a lanyard hole like p80 designs
• THE REST OF MY SPECS ARE OBVIOUSLY IN THE F3D FILE so check there first.