I have a weber "Master Touch" Grill and a iGrill2 thermometer.
The problem is where to place the thermometer during grilling. It has a magnetic base, but you cannot stuck it to the kettle, it is too hot.
So I designed and printed a small mounting plate that clamps on the front leg of the grill.
I used the little metal disc that was supplied with the thermometer.

I uploaded a new (version 2a). This one has a better grip on the leg of the Grill but only OK for very flexible material!

Prusa

I3 MK3S

No

Yes

0.2 mm

20%

The biggest problem is warping.
The supports are needed for the "cut out" for the metal plate.
The cut out is for indicating the right place to stick the metal disc.

I printed it with PLA, but on hot summer days the plastic gets a bit weak and the thermometer slides down. I corrected this by applying rubber cement on the inside of the clamp.
Probably it is better to print it with ABS or PETG.

I tried PETG with 0.2 resolution. The version 2 (not 2a) worked well.

Designed with Tinkercad