Pictured printed in SUNLU wood PLA on X1 Carbon with 0.2mm standard profile.

These were modeled to fit my kitchen drawer but they can be scaled to fit any drawer.  Their fitment is to be 3 wide.  Then height can be 3 middle - or - 1 middle + 1 long + 1 short.  Mix and match as you see fit.

Modeled drawer was 328.6mm wide by 515.9mm length by 76.2mm tall.  You would then scale the models by the proportion of your measurement.

Example:  Your drawer is 299.9mm wide by 503.5mm length by 74.5mm tall.

Scale (uncheck uniform scaling) by

Width = (299.9/328.6) * 100 = 91.27%

Length = (503.5/515.9) * 100 = 97.60%

Hight = (74.5/76.2) * 100 = 97.77%

When choosing which to print you will have 3 rows as shown in the drawer picture.  1 short + 1 long = 2 middle.  A full length is either 3 middle -or- 1 short plus 1 long plus 1 middle.

I look forward to any feedback.