Here's a caliper modeled camera fixture for the Bambu Lab camera in the P1P. Supports suggested. This is not a 100% duplication, and has some adjustments to allow easier 3D printing.

Note: I would suggest printing this model top down, but that comes with downsides. This will give you the best surface on top, and is generally the faster print, BUT this will give the clip the weakest layer adhesion (so care will be needed when installing and removing the fixture to avoid breaking it). For a stronger clip, print with one of the longer lengths facing up.  I find PLA is generally fine as the P1P chamber temps are relatively low, but I am using this in an enclosed P1P with chamber temps around 45-50C with no issues currently. However, it would be prudent to use PETG.