Can be printed with LW-PLA, has minimalist internal structure. #40g, 90cm wingspan, roughly 3.5-4cm2 of wing area. Glides well :-)

Did this project in order to gain some skills that I'll use to create printable RC planes.

Creality

CR-10

No

No

0.8-0.24

0%

Slicer: Prusa Slicer/Cura - use settings for RC airplanes as shown in youtube tutorials
Flow factor: 0.4-0.5
Perimeters: 1
Fan: 30%
Speed: 20mm/s
Temperature: 260C
Use skirts otherwise stability issues will occur

Cut wing in 4 equal parts, print vertically
Print Front Fuselage vertically, nose up
Print Rear Fuselage vertically, tail up
Cut Horizontal Stab in 2 with plane of symmetry, print vertically
Print Vertical stab vertically
Canopy: I suggest cutting it in two and printing it vertically
Wing key parts has to be printed "flat" of course

Separated into parts so that it can be printed naturally without overhangs, therefore without supports.