My Da Vinci 1.0A printer had a hard time with any supports going all the way to the arm and tray. I split the tray and arm to print separate. I was able to save 3-4hrs of printing this way. I used a cheap 2-part epoxy to glue the tray to the hand and the arm to the body. Came out nice. Made 14 prints for family. I purchased Tungsten rings for them as a gift.

*I added a new base.

Da Vinci 1.0A E3D V6 Clone

No

No

0.2

20

Da Vinci 1.0A - repetier 0.92, E3D V6 clone with bowden setup. 1.75 PLA @ 200 Degrees. 6" blue tape on removable glass with purple blue. 30 speed across the board. 0.2mm resolution.

*I used meshmixer to add 0.2mm supports to the body and arm.