After conversion to the Direct Drive and BL touch a lot of additional loose cables were flying around between the extruder and the former extrusion adapterplate.

So here are 2 small brackets to organize the cables properly. One for the adaperplate in a 90 degree orientation and one for the 2 spare holes from the Unitak3d DD adaperplate.

You can fix the cables in the  canal by inserting 2 cable ties into each other, so that you create kind of a “brigde” above the cables.

Needed materials :

• 2x M4x5mm screw
• 2x M4 nut
• 3x M3x8mm screw
• 3x M3 nut
• 8x 3mm cable tie