Introduction

The Modular tape dispenser is designed to hold any width of tape in the same container. Each dispenser has its own dimensions to fit 12mm, all the way up to 100mm wide rolls of tape. The minimalistic design of the dispenser gives it a sleek appearance, making it look good on any desktop surface.

Read The Following Before Printing

The model is designed to hold tape rolls with an inner diameter of 3 inches (7.62cm), and is not suitable for holding small hobby tape rolls or similar products. Any tape roll with a diameter smaller than 3 inches will not work with the model. I am currently in the works for a model to hold smaller rolls of tape.

Recommended Print Settings

Provided below are the recommended prints settings for this model.

Assembly

This model comes in four parts;

1. Two Panels
2. A middle piece
3. A rim

Each of these pieces will be different sizes depending on the width selected. Below is a step-by-step guide on how to assemble the model.

1. Insert the rim onto one of the panels, and ensure it is secure
2. Join the rim to the other panel, making sure that both ends are secure.
3. Insert the middle piece of the model between the panels, and make sure that all the pins on the back and front of the middle piece are secured and joined to the panels.

By completion, you should have a fully completed tape roll dispenser, ready to be put in your office space.