I wanted an outdoor temp sensor. It needs a shield from direct sunlight, so I made this bracket to hold the sensor, and a shield goes right over it. I used a size "B" drill to clean up the sensor hole and it fit perfect. I used 1/16" 308 Stainless TIG welding rod for the pins, but most anything will work. I will use a small CommandStrip to hold the bracket to the outside wall of my building. The pins sit in the shield and just slide down in the holes on the bracket. I hope you enjoy.

Printed on a solidoodle
Use a "B" size drill to clean out the sensor hole
Fit 1/16" tig rod into the shield mount holes
Use small CommandStrip to mount the sensor bracket to the wall
Slide the shield down on the mount. Pins from the shield to into the holes on the mount
Wire up the sensor to a device of your choosing (Arduino, Raspberry Pi, etc.)