This is a stand for a handheld safety razor of the type which you have to screw together after inserting a blade.

I designed this for my Merkur travel shaver, which looks like this: http://amzn.to/2Fbs2VT

If you find this part useful, please consider a Designer Tip – this helps me to keep the filament flowing :)

Prusa

i3 MK3

No

No

0.2mm

50%

Print one copy of each STL file. I used PLA. While the other pieces should print without problems, the base plate may need special attention due to its size to prevent warping.

1. Use superglue or plastic glue to attach the shaft to the base plate.
2. Glue the ring holder to the top of the shaft.
3. Hold the assembly in place with a vise or a clamp so that one of the four notches on the ring holder faces upwards and is horizontal.
4. Glue one of the rectangular holder plates to the ring so that the notch on the ring holder is glued into the recess on the back of the rectangular plate. Let it dry.
5. Rotate the assembly by 90 degrees and repeat steps 4 and 5 for each rectangular plate.