Summary

starscourge great sword as close to 1:1 scale as i could get it im no expert at this so its not a replica but it looks pretty much same ish i was going to cut it into parts but i do not know if many people would even print this if there is demand and you dont know how to cut it up i will do it

EDIT i did it its now cut and keyed for a brush handle are anything that is 24mm for support through the middle for the first 5 and then the last 3 use another pole to tie them in also i notice when i have cut them up i did not cut them to sit flat so you will have to rotate them till they are flat on the print bed in cura are any other slicer its my fault for not checking before i got finished but it will not hurt as long as you get them to sit flush on the buildplate in slicer software i will get around at some time to print this as elden ring is one of my top 2 games i have played and i did it with this sword to