half-pan for watercolor paint sets.
based on the windsor&newton cotman travel set half-pan, planning to use it to switch out colors.
notes after printing: Printed on 'standard' quality/resolution with a raft and white filament, it's a bit more flexible than the original, however it snaps in and out of the set's case perfectly! Bit tricky to get the raft off, may not need on on other printers, or turning the model upsidedown would probably work. =)
One half-pan with raft took 1.4g and 8 minutes to print (on makerbot 2x)
Printed 4 of the 'single' file together, on raft, 5.4g and about 16 minutes.

printing at a higher resolution might make these sturdier, as the walls are 1mm, so on '.2' they get two not-entirely-connected rings of material.

(insert rant about how my watercolor kit came with two blues that are made with the same ^?&!> pigment. one has some white added. artistic rage)

MakerBot

MakerBot Replicator 2X

Yes

No

.2

10%

rafts may not be necessary, the particular printer i'm using needs them, ymmv.

Sanded down edges and did a little bit of and acetone dip to seal off the top edge and insides.