Aside from it holding the keyboard up & out of the way while you're gaming, it also gives you a great lift for typing! It's on the board via hot glue.

Making this can be as complicated as you'd like it to be. I went with a course setting & didn't need any support on the half circles. I used supports only on printer. It did take a bit to finish, but not something I was overly worried about. It is long, so keep that in mind. You don't want it longer or wider than your bed!

That's it. I use it all of the time. I put some sticky stuff on it, to reduce the sliding when I type. Much depends on your monitor/TV lift & where you want the keyboard. I, am pretty happy with where it's at. I hope you are able to make it & it offers you some support as well. Be sure to like it, if nothing else.

Anycubic

Vyper

No

No

Course resolution is fine

Your standard stuff is fine

Just the standard settings worked fine