This is a magnetic phone stand using the official Apple Magsafe charging puck. This works on iPhone 12 and up. This is a beautiful acsesory for your phone wich takes advantage of the new “StandBy” feature on IOS 17, It is perfect to watch netfix on, act as a clock of simply to charge your phone. There is space on the underside of the base to glue in some sort of weight (coins E.C.T) to help weigh it down. It is printed in two species, the base/arm, and the MagSafe mount.

How to print:

-Print the Magsafe mount (the piece the Magsafe puck goes inside) flat on the print bed.

- Print the base/arm piece flat on the build plate, I would recommend using supports due to the space for wights on the underside, it also says that the top of the arm needs supports but it is fine printed with or without support. (You can remove the supports for the top of the arm using support blockers.)

How to assemble:

- First, thread the cord through the lower opening in the Magsafe mount, then click the puck into it (it fits tight so if it does not fit, just sand down the rim a little).

- Next, thread the cord into the opening on the top of the arm and down out the bottom.

- Then, click the small ⊂⊃ shaped extrusion at the top of the arm into the ⊂⊃ shaped hole in the back of the mount (I would recommend adding a little bit of super glue to make it more secure)

-Finally, if you want, you can glue some sort of weight into the cavity on the underside of the mount to make it more stable.

-done