This is a box based on a video I saw on Mr. Puzzle The box he showcased had two steps to open but I wanted more so I added another way to make it have four steps. The two-step variety is the easiest but if you opt for the four-step expect a bit of sanding to get the wheels to fit in properly.

If you want to print the regular version with two steps then print everything once except for the wheels which you need two of. If you want the four-step then print four of the half wheels.

To solve this puzzle you need to rotate it left (or right depending on how you assemble it) to about a 45-degree angle and then slide the lid forward a bit then do the opposite and slide the lid again. If you are solving the four move box then it is the exact same except you do it two more times to open the box.

Print instructions

Once printed all the parts you should start with the wheels and if needed sand them down on either side you should also sand the shaft the wheels sit on.

1. First, put all the wheels on in an alternating pattern LEFT RIGHT LEFT RIGHT

   2.Now slide the faceplate in front of the wheels and you're almost there

2. the final step is the slide the lid on making sure the rectangular slot is the last thing to slide in and you will have to get over the little bump that locks the lid in place.