The first thing my daughter asked for when I got a 3d printer was a dritten. Unfortunately, I didn't find one anywhere. After getting things set up and doing some prints, I decided it was time to try to make one.

I found some good starting points with the Kitten and Figment so all I really had to do was stick the wings into the kitten and keep messing with angles until I could get one to print reliably.

I used Tree supports in Cura to be safe, but it might be ok with good calibration and minimal or no supports. The version I posted was printed at 66% scale to reduce the time.

My example

Polyterra PLA

Tree supports

0.12 layer height