Summary

I was not happy with the original remix I did of these brackets. They were much chunkier than they needed to be, and I didn't like the way the Roam was not snug in the bracket due to the circular shape of the 'cup'. I wanted it to have a snugger fit so I did another remix from the original, using the triangular profile of the Roam not just for the end cut-out but also for the 'cup'. I also used the triangular section for the part of the bracket that fixes to the wall.

There are two designs here - horizontal mount brackets (left and right) and also a vertical holder. I've only printed the horizontal brackets so far - and one thing I notice now I have printed them is they will work either as a shelf you can put the Roam ON, or as an under shelf/desk mount that you can suspend the Roam from. This might be slightly risky as the design relies on the brackets providing a slight grip to the Roam - and if nudged they may possibly fall out - although I suspect they will be fine - time will tell.

The vertical mount has a channel in to allow you to slot the power cable through neatly. I have not printed it yet so I cannot be 100% sure the USB-C cable head will fit through - but it should!

I have added another version of the horizontal mount, that includes a full triangle shaped end-trim - purely for aesthetic reasons.

UPDATE:
Added a new version, the shower mount. This came about because I was balancing the Roam on my shower head, which was great right up until the time it fell off onto me in the shower. Turns out the Roam is quite robust after all, but got me thinking I needed a better way to listen in the shower. I have added a new horizontal mount that is designed to clip onto a 10mm glass shower screen. Tested it out and works quite nicely - just make sure you slide them on to the ends of the roam nice and far.

If you print these you are using them at your own risk!