Holder for paintng minis with around 25mm base.
Will fit 20mm - 34mm bases, but was designed for 25mm (standard).
Only non-printable part needed to assembly is rubber band.

Printing tips:
Base - upside down to minimalize supports needed.
Teeths- longwise (te same orientation as photo, or on its side) , to maximalize strength in pulling.

I used settings like that (works fine):
10% infill, 3 walls, 3 bottom, 3 top, 0.4mm nozzle, PLA


Licencing: just as shown below, original creation.