A snap-fit Samsung A22 phone case to protect the phone exterior.

It is recommended to print the case on the back face. However, the underside radius form (shape) nearest to the plate is questionable. Further reducing the layer height may improve the shape. Although, some fettling or a light scrape with a sharp craft knife does improve the finish.

As requested, I have now uploaded two versions of the case. The first (original) with a 1.0mm wall thickness and the other with a 1.6mm wall thickness for extra protection.

Printing Information

• 0.15mm (Quality) layer height.
• 50% infill.
• 0.4mm nozzle diameter.
• Prusament PLA was used.
• No Support material is required.

Please check out my other Samsung A22 phone case printed in TPU using the link below.

https://www.printables.com/model/529791-tpu-samsung-a22-protective-case