This is based on TKS's frame for 1s micro quads. I did some modification to the design as I wanted a bit more clearance for the props and more rigidity of the frame. Until now I didn't brake a single one.

See here for the original: https://www.thingiverse.com/thing:4686544

My recommended hardware is:

.) 1102 18kv motors
.) Gemfan 2023 props
.) 5in1 flight controller with emuflight and Skylion's preset
.) 500mAh 1s HV Lipo
.) Any light weight camera

The canopy is from thingverse as well, can't find it at the moment.

Ender 5

No

No

0.15

30

You may need to play with your slicer's settings to get a good strength of the frame. It's important that the outer line is a single uninterrupted line running around the whole model.
I use ironing for the top layer to make sure all layers all weld bonded on top.