Nothing super fancy here, just a few pieces. 

The bottom/base, the red “wire” part, the tape rolls and strip piece, the reels, and of course the top piece.

You'll need 4 M3 x 12mm screws and 4 nuts.  
The red “wire” piece and the strip of tape just need a touch of glue. 

Notes of caution/advice: 
- You will most likely need to widen the center holes on the tape rolls. I just took a tiny strip of sandpaper (400grit), rolled it up, and ran it through the holes for like 30 seconds each. 
- The cutouts for the M3 nuts on the base have super tight tolerances. I balance a nut on top of each hole and use a pair of vice grips (the locking pliers) to gently press the hardware in.