This is a mount made to hold a ring light on the cross bar of a Prusa MK3S. This model uses three parts (1) Clip, (2) PreasureNut, (3) BoltKnob (if you use a common 1/4 20 hex bolt) or (3) BoltPrinted (if you dont have a 1/4 20 bolt laying around). Simply clip the CLIP onto the top bar then thread the bolt into what ever accessory you intend to use (I used a ring light but a 1/4 20 bolt also works for a GoPro mount if you wanted a top down recording. Then thread on the PREASURENUT before mounting the accessory. Lasty, mount the accessory and tighten the PREASURENUT against the accessory to secure it.

Doesn't Matter

Doesn't Matter

0.20 or better

80%

This is intended to be printed with supports on two overhangs. This can be printed on its side without supports, however, the threads on the CLIP will can be compromised when printing in this orientation.

Remove supports

Fusion 360