Ender 3 Front X-Gantry Cable Support for Direct Drive front cable management to the left of the print head

I wanted my Ender 3 Direct Drive cabling secured to the front left of the printer and created two mounts:

This one &:
Direct Drive Extruder Mounted Cable Support - https://www.thingiverse.com/thing:4867538

Printing Settings
Print without supports. Has nicer curved edged with 0.16 but prints just fine with 0.2.

Parts needed:
1 x M4 bolt (Can be anywhere from 10mm to 16mm long)
2 x 4 or 5 inch cable ties

Directions:
Remove Housing from Left side of X-Gantry
Position Brace on inside and use a M4 Bolt to connect both pieces in place
Re-attach the Housing (There is a gap so the 2 original screws on left side can still be put through. They are not suppose to affix to part.
(See 3rd picture which shows the two pieces bolted together).

Dont overtighten !

Creality

Ender 3

No

No

0.16 or 0.2

20%

Install Instructions.

Remove Housing from Left side of X-Gantry
Position Brace on inside and use a M4 Bolt to connect both pieces in place
Re-attach the Housing (There is a gap to get two of the screws in place still)