This is a design of 3D printable tenting feet for the CRKBD Tented Case by RaihaX.

The feet are designed for a 12 degree tenting angle and a plus or minus 5 degree tilt angle.

Feet bases are slanted to match the tilt/tent angle and lay flat on the desk surface.

For -5 degree tilt:
Print two of each file. The smaller one goes on the pinky side, the medium one close to the pro-micro connector and the longest ones near the thumb keys.

For +5 degree tilt:
Replace the medium size feet by long feet.

Simply press-fit the feet in the case holes, attach some anti-slip rubber on the bottom of them and you're good to go. No screw or any other hardware needed.

Creality

Ender 3

Yes

Yes

200

20

For best structural strength, print feet laid flat as in the picture. Use "brim" option in Cura if struggling with bed adhesion.