A case for a HiFiBerry AMP2 attached to a Raspberry Pi Zero WH.

The 'H' is needed since you have to attach the HiFiBerry using the header. And the 'W' is needed since I didn't leave enough room for an external WiFi dongle, though you may be able to sequeeze a very small one in there.

Prusa

I3 MK3S

No

No

0.1mm layer height

15

You pretty much have to use a layer height of 0.1mm (or less) on the top part to make the labels somewhat legible. I used the same layer height on the bottom part for a consistent look.

Both parts are printed with their largest areas on the print bed, and don't require supports. I used Prusa's textured sheet to achieve the look for the top part.

Use two M2.5 screws to hold the AMP2/PiZero assembly in place. The two parts then just snap together.

Since the SD card slot, and USB and HDMI jacks are not accessible once assembled, you can only operate this in a headless setup.

So install something like raspotify before assembly!