Apple MagSafe iPhone Stand

For my new iPhone 13 Pro my wife bought me a MagSafe case and charger from Apple. I already had a phone stand but decided to integrate this new Apple Magsafe charger into a new designed Phone Stand.

The charger slips right into the hole of the Phone Stand and there is a cable exit that allows the charger to sit flat with the face of the stand.

I also tested this Phone Stand and charger without the Apple MagSafe case on the iPhone 13 Pro and it fits perfectly and charges at the same time.

At the bottom of the stand the foot has an open gap allowing sound coming from the iPhone to effectively pass with being obstructed. I had this issue previously on another Phone Stand I created where it would mess up video calls.

The Phone Stand face has an angle of 60 degrees, which I found to be the perfect angle.

Ender 5

No

Yes

70

You can basically use your favorite material

When you remove the support material after the print be careful not to break the legs or other areas of the print. The Magsafe charger is a snug fit so ensure that you carefully clear out any excess material before inserting the charger. The 1st one I printed split in 1/2 when I inserted it. I ended up increasing the MagSafe space by 0.2mm and that worked perfectly. The design file already incorporates this 0.2mm needed.