These are simple files intended to hold the floor of the heated chamber on a voron 2.4 in place. Mine would warp away from the points where it was pinned in between the din rails and extrusions.

This mod + some tessa tape over the edges changed my chamber temp from 38c at best to 41.5c typical.

I am open to help/suggestions and any help. I'm getting better at designing things but I'm still amateur at best.

Creality

CR10S PRO

No

No

0.2

40

Chamber doesn't get super hot but PLA has a tendency to deform under tension at even moderate temps. Please use a material that can withstand a reasonable temperature. ABS, maybe PETG or a high temp resin.