Summary

A few parts I've designed for my Source One V6 build. I have not tested these parts on other versions of the Source One. All parts are designed to be printed without supports.
I'm open to additional requests and ideas, so feel free to reach out!

Camera Protectors:

Thin, lightweight bumpers for the carbon fiber on either side of the camera. I printed mine in PLA, since TPU would be too floppy.
I would recommend using feet as well, or the protectors may hit the ground while landing.

RX Antenna Mount:

Tested with the stock antennas of the HGLRC ELRS 2.4 RX-T.
Uses three 2.6mm wide zip ties to secure the antenna.

VTX Antenna Mount:

Tested with the MMCX version of the Xilo AXII (using the TBS Unify Pro32 HV VTX in this case).
Uses a small section of a 2.6mm wide zip tie to keep the antenna secured at a gentle angle. Cut off the narrower tab on the end of the zip tie, then slide it into the slot once the antenna is where you want it. Then cut the zip tie, leaving just enough sticking out the top in case you need to remove it later.

Feet:

Simple sliders/feet that keep the bottom of the frame and screws from getting torn up while landing.
Make sure your motor screws are still long enough to secure the motors!
Recommended if you're using the Camera Protectors, to keep them off the ground.

Thanks to Rotor_Syndicate for the base model of the frame!