The model is to be printed in two halves and then glued together.
I made small holes on the inner side of each piece. A diameter of 1.75 mm PLA filament fits the holes. The oval depression is for placing sinkers. A ball-bearing swivel is to be attached to the tail part so that a metal blade rotates correctly.

Since the body part is flat, you can easily decorate the lure with stickers or masking tape without using an airbrush.

FlashForge

Adventurer 3

Doesn't Matter

No

high

100%

*Change of infill settings (30 November 2021)
I recommend that you print at 100% infill.
I have found that the initial setting (60%) causes extra buoyancy and the lure does not sink properly.