This storage drawer is inspired by the one created by Shatterbrain :
https://www.thingiverse.com/thing:2612534/files

I also made a version for 608 bearings in case you have these :
https://www.thingiverse.com/thing:4429253

This thing will stand up your printer control box and has some storage abilities.
You can print all the parts with a Creality CR-10/CR-10S, and you'll need to buy :

• 8 bearings (outside diameter : 16mm, inside diameter : 5mm, width : 5mm)
• 8 M4x6mm screws
• 8 M4 washers
• 8 M4 nuts

I got the screws/washers/nuts in this box :
https://www.amazon.com/Stainless-Assortment-Box%EF%BC%8CThree-Wrenches-Included/dp/B071KBVZVV/

You can re-use the rubber feet from the control box for the legs, this might help to reduce vibration noises.

I hope someone will print this ! Please tell me !! :)

Creality

CR-10S

Doesn't Matter

Yes

0.2

20-30 %

Legs

This part is pretty big but should be quite easy to print.
You will need to print :
1 x legs.stl
1 x legs_with_stops.stl
The one with stops will prevent the drawer from going backwards and stop it when closing.

Rails

You will need to print :
4 x rail.stl
You will have to rotate it 45° because it's too long for the 300mm x 300mm CR-10's bed. Once it's rotated, you can even print the 4 parts in one print.

Drawers

You will need to print :
1 x shelf_bottom.stl
1 x shelf_top.stl
You won't be able to use a raft or a skirt, you'll have to use a short Brim eventually (like 1mm)

If you can, try to tap the holes for the rubber feets with a M3 thread.
Then use the rubber feet original screws to attach them on the bottom of the legs.

Then, the assembly is quite simple : use your screws/washers/nuts to attach the 4 railings and the 2 leg parts together. At first, don't fully tighten the screws, there's space for adjustment to make the control box fit perfectly on top of all of this, so that it doesn't move.

Finally, you can put the 8 bearings and place the drawers inside and you're done !