Basically a while ago i was bored and decided to make a knife from a sketch using SolidWorks. There is also a version with a clipped point which i might add if someone wants me to. The first version is improved by the V2 in the way that i fixed the consistency of the bevel width caused by making a bevel without compensating for the distil taper. i think i also improved the false edge a bit in the V2.

Note: my funky screws never worked properly, i couldn't figure out the 3D printer tolerances so i just used nuts and bolts from a prosthetic arm project called "Black Ram", which i marked this as a remix of, since i technically included the nut and bolt from it in my assembly, and i couldn't spend the time fixing and testing my own faulty design.

Note 2: The Black Ram screws are a tad too long so you will have to shorten them if you decide to use them.

Creality

CR-10S

Doesn't Matter

Yes

100%