Catch Basin Riser (6 Inch Round)

This is a catch basin riser for a 6 inch round catch basin, such as a 6 inch Spee-D catch basin. Our lawn was raised by 2 inches in one spot and by 4 - 6 inches in another. I was having a hard time finding a riser for our catch basins in my local hardware store so I created this model instead. I printed mine at 0.28 mm, 3 wall line count, with PLA. It's not recommended to use PLA if it's going to be out in the heat but so far mine have held up fine in California weather for over a year.

I've included four riser sizes with this model: 2 inch, 4 inch, 6 inch, and 8 inch.

If you would like to make your own customization then feel free to use my Tinkercad model with this link: https://www.tinkercad.com/things/9B4KdyaG0sz

Creality

Ender 3

Doesn't Matter

No

0.28 mm

20% or higher

Printing Notes

You should not need to use supports on this model. I recommend using 3 wall line count or higher.