In order to mount a Megane Cadence Sensor to the wheel of your elliptical workout machine, the instructions says to use double sided tape. However, that would make the sensor not removable (either to change batteries or to move it to another machine). So I created this mounting block that I could stick to the wheel of my elliptical machine and I can then mount the sensor to the block using the rubber grommet/bands it comes with. The size of the block is so that it can take up the slack of the band (the smaller one that comes with the set), be the same shape as the Megane sensor, and have enough surface area for double side tape to stick to on the bottom surface. The band can be slipped on the block, and the Megane sensor attached as in the rendered photo.

Printrbot

Printrbot Simple Metal

No

No

200

20

Pretty easy to print. Just make sure to have the larger flat side down, and the rest prints without supports.