Protective sleeves for the 40mm (6.3mm diameter) Yale Standard Protection Locks.

To print the bottom and top models, use TPU in vase-mode to get a strong single perimeter continuous spiral. After printing, let the printer cool down before removing the parts. Carefully cut the bottom for the key access.

To assemble the sleeve, put the bottom sleeve onto the lock. Then, slide the top sleeve upside-down onto the lock, sliding it over and carefully slide it over the bottom sleeve.

The top sleeve is available in 15mm and 20mm to suit your needs.

Please note that these locks are meant for indoor use. However, with this sleeve, they can withstand a bit of abuse.

Creality

Ender 5

No

No

0.2

Printing with a 0.6mm nozzle.

Print with Cura vase mode or “Spiralize Outer Contour” or equivalent setting in your slicer of choice.

5 bottom layers is sufficient.

Print with the print cooling fan set to 0% (OFF) and let the printer bed cool down before removing the part to ensure maximum strength. If your printer is set up for PLA, remember to adjust the Material Flow Rate to 112% or what is appropriate for your printer to use TPU.