5-10W lighting/lamp for 3D printer with 30mm Alu frame. For example Rebel II and clones. Designed for right side, for left side just mirror model. Stl and Step model included. Plastic holder includes simple shade to prevent glare of operator.
BOM:
printed plastic holder (less then 58ccm plastic)
M6x12 (for example DIN 912) bolt + nut into alu profile
Aluminium heatsink (50x50x30mm) mine is from older AMD cooler (or chinese 50x50x11 with 5W)
5-10W 12V LCD array. (1-2E on aliexpress sold for car interier lightning includes 2pin connector )
2pin cable with 2,5mm connector connected o 12V source

If u have another 50mm heatsink just edit included step model.

Rebel ozmod

No

No

0.25

33% +

Use ABS or material with similar temperature resistance. Better infill means stronger holder. but 33% and 2 outer lines are enough.

U need to use nut with Alu profile and bolt M6x12mm. Remeber to insert nut into profile before u fix printer frame otherwise its little bit tricky. Small hole in shadow is used for LCD eletric cable including connector. if u use screws for extra safe lcd fixing on coller u may need to little bit grind down first spur on coller guide grooves.
For 5W smaller array u can use 1,5$ heatsink from ali 50x50x11mm and apropriate 11mm holder model.
Remember 10W LCD is enough to iluminate small room for most people is 5W version more then enough.