Upload of my model created in May 2024.  It was printed on a Prusa Mk3S+.

With the accelerometer mounted to the case, it can become overly sensitive if you modify the AtGames Legends Pinball Micro with any additional speakers, exciters, plungers or solenoids. This model allows you to instead mount it in the middle of the case and isolated from any sources of vibration.

You will need at least one rubber band to use this, I used three. I also found a bit of foam underneath helps adjust the sensitivity further.

Info on my AtGames Legends Pinball Micro modifications:

Plunger: I use this one from Etsy: https://www.etsy.com/uk/listing/1414840046/pinball-plunger-mod-fits-atgames-legends. It's not very accurate, because it's just emulating a button press, but I like the feel it gives for casual play. There are more complicated ways to use an analogue plunger (for OTG only) but I'm yet to venture into it.

Solenoids: I use the solenoids from Cleveland Software Design: https://www.clevelandsoftwaredesign.com/pinball-parts/p/solenoid-flipper-button-control-boards I don't use a seperate PSU and instead split off from the stock one.

Speakers: I use the stock speakers but with this amplifier: https://www.amazon.co.uk/gp/product/B09SL33VYD/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
I use this to bring the output from the stock audio board down to line level before being amplified again by the new amplifier: https://www.amazon.co.uk/gp/product/B0CGRZG43Y/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 This isn't ideal as it's going through amplification, deamplification and then amplification again. But the sound quality is still better than using the stock amplifier, even with the stock speakers. Again, I'm using the stock PSU.

Exciters: I use the Dayton Audo DAEX25: https://www.daytonaudio.com/product/1087/daex25-sound-exciter-pair. These are powered by the subwoofer out on the amplifier I use with the speakers.