Very simple test to print and manual adjust the level of your printbed (Adjust the offset) when you just installed your ABL or changed the nozzle.

Adjust width and depth size in your slicer to match your buildplate but beware to not change/scale the height of the print. (0.2mm = 1 layer)

Ideal for usage with for example ezABL, ABL, 3D touch, BL touch or any random other probe you use to level your bed automatically.

1. Make sure the possition of your probe is just a little bit lower then your nozzle (so the nozzle does not crash into the buildplate during ABL)
2. Do a ABL run
3. Print this item and adjust the offset during print until you are happy with the bed adhesion and first layer.
4. Save the offset to the firmware or EEPROM

   Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

0.20

Notes:

Category: 3D Printing Tests