Don't junk a piece of old hi-fi gear over a piece of broken plastic! Replacement for the part on the leaf switches that always cracks. This was made specifically for an RH-65 8 track recorder program change switch, original switch part number CSN-035. It's likely that a similar switch was used in other equipment. Designed from an original (broken) part.

Recommended print orientation is with the slot in the back horizontal, the switch leaves are very thin and I didn't get the slot for it to print properly in other orientations. If the slot is horizontal, it works fine with a 0.4mm nozzle and a standard print profile in Cura. Recommend tree supports.

Avoid bending the switch leaf when installing this tip. It takes a little bit of force but it should slide right on and click onto the dimple. Use at your own risk, of course.

Will it last as long as the original? Dunno, but at least it's a quick print.