Rear bumper for the TBS Source One V5 FPV drone frame. For use if you have the VTX antenna mounted somewhere not on the rear (eg. side mount). Fits standard standoffs well.
Recommend to print upright, raised from the bed and supports used to support the bottom where needed since the ends of the bumpers decline.
Recommend to print in TPU, I printed with 4 walls and 15% infill but you can do as you see fit.

Protrudes just a few mm further than the rear arms, so I might make another version that is 5-10mm longer so that it takes rear impact instead of the arms (hopefully)
Made for use to protect rear of frame when doing reverse tricks, mattys, or anything that requires reverse flying.