I found a plastic folding table at Walmart and had the idea to cover it in felt so it was better for playing cards and stuff. I then thought it'd be smart to put a border around it to keep stuff from falling off the edge as easily. The table measures around 2 feet by 4 feet, the uploaded design is half of that so 2 by 2 feet. I printed it on my Neptune 4 Max but even still I had to cut the design up further (I did it into fourths) but you may need to cut it smaller to fit your print bed. There are cut outs for the functions of the table (namely the hinge and the clasp) so keep that in mind. Also there was a small gap in the middle by the clasp so I measured and cut a little bit to that the loop was complete.