Ok needed a coupler to go from the motor to get it attached to the shaft of the auger, so I made one. It's only 30mm long but it connects to the motor by the means of a "Hex Shank Socket Adapter". This item is listed below, you have you choice of socket size depending what you purchase at your local hardware store. I have posted Lowes products because they are the closest to me. Also I like this item being made out of abs, as it's strong enough to turn the auger but weak enough to break if there is a problem, takes out the need of a snap pin. Hope this helps anyone creating a filament extruder or any other item with the motor listed in the Lyman Motor Mount.

Oh yeah print it the way it sits or you WILL NEED supports, and good luck getting them out of the openings....

Here is the Hex Shank Socket Adapter link:
http://www.lowes.com/Search=hex+shank+socket+adapter?storeId=10151&langId=-1&catalogId=10051&N=0&newSearch=true&Ntt=hex+shank+socket+adapter#!

http://www.tractorsupply.com/tsc/search/hex%20shank%20socket%20adaptor

http://www.homedepot.com/s/hex%2520shank%2520socket%2520adaptor?NCNI-5

This is the motor that it connects directly to:
http://www.ebay.com/itm/321131266241?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT