Wanted a base for the TP-Link Tapo C100 camera to use with the BambuLabs A1. I started with the typical adapter that attaches to the A1 screen and though it works fine I wanted an alternative that did not add weight to the screen. In doing so I found the simple stand (original source: https://makerworld.com/en/models/856556) and lengthened the neck so the camera sat approximately at the same height as the adapter that uses the A1 screen. I also reduced the head (ball joint) of the adapter to roughly 99% on the XY directions to give it a tighter grip of the camera. Printed in Atomic PLA though PETG is probably best for these type of joints.