This is a remix of two different models:

• Nazzaf's: https://www.thingiverse.com/thing:1198514
• Barspin: https://www.thingiverse.com/thing:113764

Barspin's frame held the camera nice and tight but made it difficult to insert and remove the GoPro camera and did not have the openings correctly placed for the Hero 3+ mics. Nazzaf's frame made it easy to insert and remove the camera, had the openings placed correctly for Hero 3+ mics, and had bigger holes for the buttons (which I liked since I would be using this while skiing with thick gloves). However, the camera did not fit in the frame tightly and would rattle.

I took both of the best aspects of each of these designs and put them together while also allowing spacing to mount the GoPro protective lens (https://www.amazon.com/GoPro-Protective-Lens-Official-Accessory/dp/B00F19Q3T2) which I always use when running my GoPro in with a frame housing.

EDIT: I modified the stl a bit to make the frame more sturdy and less flexible. I basically removed one of the clips and made the remaining clips shorter. Therefore, the current stl file will not look exactly like the frame shown in the pictures. It will have three clips instead of four.