This is a stand for the Choyong WT2 Shortwave/FM/MW/UHF/Internet Radio. It's a remix of the holder for a belt clip.

On thing that make a stand useful is that it holds the radio in place while charging. The USB port it poorly designed and the least bit of motion will cause the cable to pop out.

I printed this with ABS because I needed to print something else with ABS at the same time, but it should do fine with PLA.

I experimented with various orientations in my slicer (upright, upside down, face down, face up, sideways) to see which was most economical because of the supports. Upright used the least filament (and was quickest).

This radio can be used on the 70 cm. amateur radio band in addition to all of its receive functions.