Made a replacement Part for an Hp Probook 6570b.
It is the latch button you slide to open the lid of the laptop with.

i did not put the hooks on the bottom as it would not slide into the two points it connects into. i plan on using a heat source to slightly melt the plastic in place so it does not pop out. if anyone can model it up to where it can be don with out doing so i would greatly appreciate it.

If you guys need to mod it feel free to do so.

it was printed on a XYZ pro 3-in-1.
at 90% infill
.1mm height.

minor cleaning needed.