This is a pint to wall mount the TP-Link EAP225 Omada Access Point horizontally. The AP can be wall mounted per the directions, but I wanted to be able to mount this to a wall in a building with tall, vaulted ceilings where running Cat6 cable would be difficult. I also wanted to maintain the horizontal antenna orientation to maximize the signal distribution.

This is a lightweight design that is strong enough to hold the Access Point without fear of it breaking. Use either a stud plus a drywall anchor or two drywall anchors to mount this to your wall. Great for open rooms with difficult to access ceilings.

I printed this using PLA+ from "3DJIAWEI" on AliExpress at 205C and a 55C bed on my mostly stock Voxelab Aquila.

I did not use supports for the 18mm hole for the RJ45 connector to fit through and it printed alright in both 0.4mm and 0.2mm resolutions.

I attached the mount to the included bracket for the AP using m3 screws. Anything will work as long as the head is not too proud.